RD-500SV RD Series BGA/SMT Rework Machines

Feature

Multi-functional profiles can be handled at will Wide support to industrial large-scale and small-scale circuit boards, including 01005 components

Manage your profiles completely freely

You can control the temperature from the basic 5 zones up to a maximum of 30 zones, in whichever way you want. This way you can freely produce a very detailed temperature curve. In addition to this temperature management, you can set the equipment’s operations per zone, even in cases when a special movement by a circuit board or other component would make operating it difficult, and save the settings, so you can cover every possible scenario.

3-point auto-profile Create a profile automatically by targeting pre-set values for the following 3 points: solder parts, device surface and circuit board surface. With this, the heating period and the heaters’ temperature will be regulated automatically while you manage the device’s guaranteed heat-resistance temperature or the temperature for the circuit board which prevents it from bending.

One click advanced settings are supported in Easy-Selection mode

The QFN, QFP and other components control phenomena which cause the components to move during the flux’s active time.
These variations in position make it necessary to add a certain amount of pressure to the components.
Also, in order to perform operations consisting of multiple steps for the removal of certain components, it becomes necessary to repeat the movements of the Z axis or adsorption operations, but with the RD-500V series it is possible to configure these movements per zone.
However, making detailed configurations can prove to be a very time-consuming activity. Nonetheless, if you use the Easy-Select Mode with the previously created profiles, you can apply complex settings from the zones which support certain components.

Ex:Issue with POP